![]() Save the transformationĪfter adding control points manually or loading them from a world file (. To open the Control Point table, click Control Point Table in the Review group on the CAD Data tab on the Tools tab. In the Control Point table, you can modify the numeric values of your control points as you create them. To update the map display based on the control points created, click Apply. To add control points, click Add Control Points in the Adjust group on the CAD Data tab on the Tools tab. Control points allow you to snap specific CAD features in your dataset to corresponding features in your control data. Add control pointsĪdding control points is the best practice for conducting a precise georeference. These tools are in Prepare group on the CAD Data tab on the Tools tab. The Rotate, Move, and Scale tools allow you to manipulate the dataset without using control points. In most cases, positioning your dataset before closer to its final position before adding control points can help you complete your task more efficiently. If you need to scale the file further to fit your map, see the section below. This shifts the dataset to fit the current view, regardless of where it is located. When this happens, zoom to the destination area and click Move To Display in the Prepare group on the CAD Data tab on the Tools tab. If the CAD drawing's origin coordinate (0,0,0) is significantly different than that of the map projection in your data frame, the CAD dataset may be added outside your data extent. Assigning a spatial reference is a best practice for producing an accurate transformation. If your CAD dataset does not have a coordinate system defined, you can apply one using the Define Projection tool in the Alignment group on the CAD Data tab on the Tools tab. To display the tab, select a child feature layer in the CAD group layer. The CAD Data tab is not visible when a CAD group layer is selected. ![]() Once you have georeferenced a CAD feature layer, you can add the other feature classes of that dataset to the map and they will be constrained by the same control points. Georeferencing a single CAD feature layer applies that transformation to the entire dataset. Choose a georeferencing layerĪll commands and tools on the CAD Data tab act on the CAD feature layer selected in the Contents pane. The methods you use and the order in which you perform them can vary depending on your data. The sections below are organized in the order of a typical georeferencing workflow. Click Georeference in the Alignment ribbon group. To display the tools, select a CAD feature layer in the Contents pane and click the CAD Data tab. You can use these interactive tools to reposition the data, as well as register control points to specific geographic coordinates. ![]() To be honest, thank you for reading my TASKr Review ! See you later.The tools needed to georeference a CAD dataset in ArcGIS Pro are located on the CAD Layer tab. I love material that does NOT leave unanswered questions, has a real case study and it can easily be duplicated. It's a COMPLETE, step-by-step system that nobody is doing (at least not this way). If this sounds familiar here is something that will help you remedy that situation. I feel bad when I hear story after story like this because I know EXACTLY why it's happening. Some people are working a flawed method and do not have a reliable SYSTEM to pursue. When someone has tried & tried, taken massive action, put in the hours but still has nothing to show for it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |